SEBO Central Vacuum Wand Adapter with 34 in. Cord for ET-1, ET-2 and ET-C Power Heads

Running a SEBO power head from a central vacuum system comes down to one piece of hardware, and part 2780AM is it. The adapter joins an ET-series head to 32 mm central vacuum tubing and arrives with a 34 in. black cord already fitted, so current reaches the head without any wiring on your part.

Fitment covers the SEBO ET-1 and ET-2 power heads in both switched and unswitched builds, and the ET-C power head as well. The cord runs up to the wand handle end and terminates there, which is how the head draws current from the wand circuit in the same way it would on a SEBO canister. The moulding is finished in gray black, so it reads as part of the ET housing rather than as something bolted between two systems.

This is the part that fails quietly on an older installation. A cracked collar lets the wand rock inside the head, and a cord that has been walked on and pulled tight at its strain relief loses continuity long before it looks damaged. Either fault ends the same way: the brush stops turning while suction carries on as normal, which sends most people looking at the head or the motor first.

• Part: 2780AM wand adapter for central vacuum systems
• Tube size: 32 mm
• Cord: 34 in., black
• Color: gray black
• Fits: ET-1 and ET-2 power heads with or without switch, plus ET-C power heads
• Related: 6272CA and 6272PI, the SEBO telescopic central vacuum wands for ET-1 and ET-2
• Replace when: the collar is cracked, or the cord has lost continuity at the strain relief

Two details make this the right adapter for a central vacuum installation rather than a canister accessory: the cord that carries current to the head, and the 32 mm tube size that matches central vacuum wands. The ET-C is covered alongside the ET-1 and ET-2. If a head runs intermittently when the wand is flexed, the fault is in the cord or its terminations rather than in the head, and this part renews both together.

Genuine SEBO component, shipped in 2-5 business days.